About network1215

network1215 · 04-16-2021

I am trying to push software update to FTDs from FMC FMC running 6.6.1 version and same version trying to push on FTD but it gives error message. Pre upgrade validation - snort version on device is out of date. Deploy access control policy from FMC ...

network1215 · 04-09-2021

Folks, I am trying to initiate a ping from my FMC Cli but I do not see Ping command available in CLISH mode.. All I see >ConfigureExitShowSystem When type system. Sytem> It will give other options but No Ping, configureexitexpertgenerate-troubles...

network1215 · 09-10-2020

Hi All, I am bringing up fabric with APIC version 4.1(1l). some of the leaf we received has older code and I would like to upgrade as stand alone switches/leaf before APIC can discover the leafs. Unfortunately My APIC is unable to discover these leaf...

network1215 · 03-07-2020

Hi All, I am trying to ssh and launch ASDM for management IP of ASA. I have ASA with SFR Module. (SFR Module is using mgmt0/0 port for communication, no ip assigned physically on interface and port is connected to management vlan as access , works f...

network1215 · 03-04-2020

When I am on corporate wifi I am able to access WEB gui for WLC but when I am connected from home via VPN I am unable to access WLC GUI.. however, I am able to ping from PC(connected to vpn) to WLC management IP. All the GW are on ASA for vpn subnet ...

network1215 · 04-09-2021

Thank you gents

network1215 · 09-10-2020

you are write.. I reload my leaf's one more time and than they appeared in APIC.. Now I will use the GUI for the upgrade. Thanks.

network1215 · 09-10-2020

unfortunately, I am unable to discover the leaf switches via APIC. They are not showing up in controller GUI. That is why I was thinking it is probably IOS version issue.

network1215 · 05-22-2020

Thanks for precise answer. We have a basic SVI configured with default gateway, also ISE authentication is enabled on some of the ports(Mab commands). is there any configuration change ? Also you mentioned Rommon upgrade, do I have to use same .bin...

network1215 · 03-07-2020

yes I can ping it. no problem.

Member Since	‎08-26-2013 07:33 AM
Date Last Visited	‎04-23-2021 07:34 AM
Posts	50
Total Helpful Votes Received	10

User Statistics

User Activity

snort version on device is out of date

How to generate a ping from FMC GUI or CLI

Nexus N9K-C9348GC-FXP in ACI Mode upgrade

unable to ssh or ASDM from inside subnet to FW management IP

unable to https wlc while on anyconnect vpn

Re: How to generate a ping from FMC GUI or CLI

Re: Nexus N9K-C9348GC-FXP in ACI Mode upgrade

Re: Nexus N9K-C9348GC-FXP in ACI Mode upgrade

Re: 2960s switch - Can I go from Version 12.2(55)SE to 15.2(2)E9?

Re: unable to ssh or ASDM from inside subnet to FW management IP