asbesi001
Level 1
Level 1
Member since ‎08-21-2013
‎08-18-2017

User Statistics

  • 40 Posts
  • 0 Solutions
  • 11 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
20 Replies
10 Replies
5 Replies

User Activity

Hi, After configuring SIP-UA on CME, I see that besides the username there are also all my ephone-dn trying to register to that SIP Server. the ephone-dn is configured with no-reg both commend as below: ephone-dn  1  dual-line number 234 no-reg both ...
Hi, Does anyone have experience in using third vendor POE injector for AIR-CAP1702I-E-K9? From the datasheet of 1702 is mentioned that input power requirements are 44 to 57 VDC. Can we use Ubiquiti power supply with output: DC 50V Thnx, B
Hi, I recently installed the IP communicator on a laptop with the UC560 system.  I have set the TFTP server ip address as the UC520 address which is 10.1.1.1 on the local network.The phone has identified itself to the UC560, can place and receive ...
Hi, I am having an issue with Cisco Switch SG200-50p. IP Phones on Voice VLAN have connectivity, but PC on data vlan do not have connectivity. On the logs of the switch I see this error:  %CDP-W-NATIVE_VLAN_MISMATCH: Native VLAN mismatch detected on ...
Hi, I am trying to configure WAN port on UC560, but not sure if it supports encapsulation dot1q? need to create more than two sub-interfaces on the WAN port. Did anyone configured such scenario? Thanks, Bj
Community Statistics
Member Since ‎08-21-2013 05:46 AM
Date Last Visited ‎08-18-2017 06:48 PM
Posts 40
Helpful Votes Given To