About RAJMOHAN RAMAMOORTHY

RAJMOHAN RAMAMOORTHY · 12-28-2015

Hi, How the configured ACLs are processed in ISR routers (C3800 / C3900), is it processed in Hardware / Software (CPU) ? Does ISR has TCAM for ACL Processing ?

RAJMOHAN RAMAMOORTHY · 04-28-2015

Hi,How can I find which all TE tunnels are flowing through a certain RSVP enabled Interface and what is the amount of bandwidth reserved by each TE tunnels?

RAJMOHAN RAMAMOORTHY · 10-12-2013

Hi everyone,I wish to deploy DAI (Dynamic ARP Inspection) for a non-DHCP Environment where all connected hosts are assigned with a static IP address.ARP ACL as recommended in Cisco Docs can be used to achieve this so that ARP spoofing / poisoning can...

RAJMOHAN RAMAMOORTHY · 08-22-2013

Hi,I want to poll and verify the state of NVRAM in C6509 devices.Because the issue of "Configuration lost" after device reloads were observed.I thought of proactively monitoring the state of device NVRAM.Which MIB and OID will help me in monitoring t...

RAJMOHAN RAMAMOORTHY · 08-19-2013

Hi,I have two C6509 (SXI9) deployed as HSRP active and standby routers with SVIs configured on both.Also IBGP is configured between then over the SVIs.During the active router failure, the HSRP converges faster and the standby becomes active.However ...

RAJMOHAN RAMAMOORTHY · 10-14-2013

Hi David,Latest IOS release for your router seems to be 12.4.25d (Maintenance Deployment) released on Aug 10.Based on Memory availability on your router, I suggest to upgrade the IOS image to the following one:IP BASE with Crypto support - c2600-ipb...

RAJMOHAN RAMAMOORTHY · 10-14-2013

Hi sean, Did you try configuring "switchport nonegotiate" along with switchport mode trunk to disable DTP.Set this port as trunk port unconditionally.Also check, is there any STP issue which is causing this issue.Verify the output of show spanning-tr...

RAJMOHAN RAMAMOORTHY · 10-14-2013

Hi John,You can try applying an inbound service policy to these switch ports using MQC (Modular QoS CLI)For example, assuming the following details about IP PhoneIP Phone Subnet: 192.168.0.0/24First configure an extended ACL to match traffic origina...

RAJMOHAN RAMAMOORTHY · 10-14-2013

Hi Javier,How can we integrate ACS with RSA Authentication Manager for two factor authentication.How does the two factor authentication work in this integration scenario?Is there any other App other than RSA, we can integrate with ACS for two factor ...

RAJMOHAN RAMAMOORTHY · 10-14-2013

Hi David"its not allowing me to do the command 'encapsulation dot1q' while trying to create a trunk port."Ideally we cant create Trunk / Access ports (switchport) in Routers (C2621)."encapsulation dot1q" command cant be applied on Physical interface ...

Member Since	‎08-07-2013 09:02 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	24
Total Helpful Votes Received	10

User Statistics

User Activity

ACL Processing in ISR

TE Tunnels flowing through Interface

Dynamic ARP Inspection for non-DHCP Environment

LMS 4.0 - NVRAM state

C6509 - BFD Support over SVI

Re: Beginner Needing Help!

Trunking port

First QoS Deployment

Ask the Expert: Installing and Configuring Cisco Access Control

Re: Beginner Needing Help!