Hi team,please, take a look at the pics below. Arrows show direction of calls, green work, red doesn't work.I have 3 offices with the VCs systems, everything works fine, instead of incoming calls from London to Berlin. I can accept the calls from Lon...
i team, we experiencing S2S VPN connection issues, it's often drops for no reason almost every day in a week. There are 30+ other S2S VPN to other customers on our side which work perfectly well. In case of the bad-working VPN we suspect a Lifetimers...
Hi everyone,
what most likely could be a reason for WLC's syslog message like this:
"Unable to send EAPOL-key msg - invalid WPA state (0) error"
I have a SSID with radius (NPS) auth which has been working for about 2-3 years and accidentally st...
Hello, team,
I have WLC 8.5 with Flexconnect topology. My download/upload speed is about 30Mbit/s. When I turn on Flexconnect Local switching (when wireless traffice goes directrly to gateway without reaching the WLC) I get 60Mbit. WTF???
All my ...
Hi, Joseph, CSW01 is Cat4507 switch
"One method would be to run a dynamic routing protocol between the 3 devices, and have CR01 and CR02 as equal cost from CSW01."
I've added to maximum-paths to my OSPF configuration but it seems there is no resu...
Hello, Joseph,
many thanks for your reply.
So, you mean that GPLB is not a proper solution in my case? Then, what else?
OSPF maximum-paths?
My primary goal is to provide load balancing and fault-tolerance for Internet connection. I have 2 I...
Evening, Georg,
May I ask you? Should I see Virtual GLBP address in trace output? When I trace something beyond the GLBP routers...? I ask because I've configured a small lab in GNS and don't see Virtual address in trace.
Full show-runs from CR01...
