Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
Just after some general advise on an MPLS design decision.
A large enterprise is to have a MPLS infrastructure that contained multiple data centres, and branch offices. The data centres would have firewalls, but the branch offices would not. ...
Hi All,
Due to high memory utilisation, Cisco TAC have advised that I execute the following command;
"object-group search access-control"
I'm keen to understand the impact of the command, and determine the actual changes being made in executing the...
Hi All,
Looking to purchase two Cisco WS-C3850-48T-S with C3850-NM-4-10G modules. All four modules per switch will be populated with SFP-10G-SR= 10G SFP modules.
Before proceeding with the purchase, im keen to obtain clarity on the following;
Two of ...
Hi All,
I'm very new to QOS and have some questions.
1. If I enable "mls qos" on the access layer switches will the MLS QOS markings set at the access layer be automatically read at the core/distribution layer, or does the "mls qos" option need ena...
Thanks for the information. I can see that some of the interfaces are experiencing output drops. Can you confirm the following; 1. Which interfaces do PC’s A and B connect to on the C3750? 2. Do both PC’s reside in the same VLAN? 3. What are the asso...
Thanks for the information, however please could you provide the "show interface" output for the two interfaces connecting to the PC's.My assumption at this stage is that you are experiencing a duplex issue, which could be causing the poor performanc...
Hi Paul, Just to clarify, are both PC's connected to the same switch, or do you have an uplink between the C2950 and C3750? If the PC's are connected to the same switch, do you observe the same behaviour?
Hi,
Thanks for the information.
Ok, for you to achieve the desired setup you will need to establish the following configuration;
1. Establish a FlexConnect group on the WLC, and add the Ethernet MAC addresses of each of the AP’s in the Wisconsi...
