Is it possible to have the Cisco InTouch panel/system trigger an event on a ethernet enabled Crestron controller?(The codec does not have GPIO outputs so I believe it has to be done over ethernet if possible)-Torje
HI Paulo,Yes, I read that in the article. This is regarding extension with a regular USB-A-F to USB-A-M 2metres cable. I am aware that this works, but wonders if anyone has tested extension with TP-based extenders and done this with positive outcome....
Actually, I am shocked I did not think about that... I was too hung up in the Cisco actually sending a command to the Crestron... The Crestron should just monitor the settings change like you say. Should do the trick. Thanks