Hello Aaron,
I am having the similar requirement - along with that. Customer also wanted PRI Redundancy.
Means - if one of the PRI goes down - the call has to be routed through other PRI.
Any ideas to achieve this request.
-Chandra.
Hi,
Just wanted to check if the below link answer your question.
https://bst.cloudapps.cisco.com/bugsearch/bug/cscut72237
https://bst.cloudapps.cisco.com/bugsearch/bug/cscvb16647/
Thanks
Trunk Group used <dial-peer voice 101 pots> and <dial-peer voice 201 pots> uses the same trunk group as the Primary dial-peer with preference 1. Ending in no reduncancy. Hope this must be typo error.
I resently did a factory Reset of 7911G phones:The step i followed were1. Power up the phone (unplug power cable and plug in again and hold the # key.2. Release # when MWI starts flashing.3. Press 3491672850*#.Observation: a) the mwi started blinkin...