About Jannik Hochfeld

Jannik Hochfeld · 11-08-2017

Hello everyone,I am looking for a solution to add a Meeting to Codecs based on TC or CE Firmware. I would like to use the solution the TMS or CTM are using to add a OBTP to the Touch Panel. We want to use a self written meetingroom booking tool. A bo...

Jannik Hochfeld · 06-02-2016

Hi everbody, i have a short question if the scenario i am going to explain is possible, and if, how we could achieve this. We are planning to deploy a third party UDS Phonebook to some endpoints and it already runs fine when the endpoint, that uses i...

Jannik Hochfeld · 03-18-2016

Hello everyone, is it possible to register the C90 Codec of a Tandberg T1 at the CUCM? We are currently trying to register one, but the state of the registration is always "Failed: 485 Ambiguous". The CUCM tells us the registration is rejected. Is i...

Jannik Hochfeld · 01-15-2016

Hi everybody, I am wondering if it is possible to enable a presence status for MX or SX Devices, so that if they are added to Jabber Client Contacts, they show if they are up and running of if they are unplugged from powercord or if they are busy in...

Jannik Hochfeld · 03-31-2015

Hi everybody,is there a best practice or some approved way to move over 500 Movi Users from a TMS setup to a CUCM Jabber setup?It is a bit awkward to do this manually user per user. Kind Regards,Jannik

Jannik Hochfeld · 01-11-2018

Hi James,I actually did something similar to this for myself now. I did a Wireshark trace and recorded the API POST and GET Requests required to create a OBTP on the endpoint and repoduced them via a PHP Script. Now I can use them in our small scale ...

Jannik Hochfeld · 11-08-2017

Hi Ron,thank you for your reply. You want to use TMS for scheduling meetings via MSFT Exchange/Outlook or you want to create a custom booking interface, I am not sure of the question here... I want to create a custom booking interface without the use...

Jannik Hochfeld · 06-20-2016

I would not recommend such an construct, because i think Cisco will sooner or later integrate the acano edge into the expressway and if that happens your construct will no longer be supported.

Jannik Hochfeld · 06-06-2016

Yes, thank you Leszek! That did the trick. Now the phonebook appears on the MRA registered devices.

Jannik Hochfeld · 05-31-2016

We had to get in contact with Cisco Licensing to get a option key that converted the T1 Codec to a simple C90 Codec. Afterwards it was possible to register it to CUCM.

Member Since	‎07-16-2013 06:04 AM
Date Last Visited	‎02-23-2024 12:04 AM
Posts	33
Total Helpful Votes Received	1

User Statistics

User Activity

Adding bookings to TC or CE based Endpoints

3rd Party UDS Phonebook via MRA

Using C90 Codec from Tandberg T1 with CUCM

Presence Status for MX/SX Devices

Migrating TMS Movi to CUCM Jabber MRA

Re: Adding bookings to TC or CE based Endpoints

Re: Adding bookings to TC or CE based Endpoints

I would not recommend such an

Yes, thank you Leszek!

We had to get in contact with