About wimpog97

wimpog97 · 09-22-2014

Is there a way to do switchport port-security violation {protect | restrict | shutdown} in SG-500-28P in case of a BPDU Guard violation?Seems like the default option is shutdown and I don't know how to change it.Thank you!

wimpog97 · 09-08-2013

Hi,I'd like to know how to configure VLANs in SG-500 with it's L3 functionality (switch router).The switch is up and running currently in L2 mode and has a few hosts connected to it.Some questions I have:If I switch it to L3 (set system mode router) ...

wimpog97 · 09-06-2013

The standare Cisco IOS command is show mac-address-table. This command isn't available on this switch.FW v1.3.0.62Thanks.

wimpog97 · 09-28-2014

I will give this a try. Thank you!

wimpog97 · 09-25-2014

Thank you for your reply.Can't I just go from 1.2.0.97 to 1.4.0.88 directly?

wimpog97 · 09-24-2014

Thank you for your reply.Unfortunately, this command is not available in Global Configuration mode. Is it for a different firmware version?Here is the output of show version: Unit SW version Boot version HW version ...

wimpog97 · 09-09-2013

Thanks Tom, I'll give it a try.I think, all I need to do is dedicate a few ports to another VLAN and plug the devices to them. That'll give me a separate logical switch, right?

wimpog97 · 09-09-2013

Hi Tom,What if I just want to put a few ports into its own VLAN so they can act as a separate switch connected to a separate router interface, what do I need for that? No inter-VLAN routing is needed.The switch should limit its traffic only to these ...

Member Since	‎09-06-2013 05:24 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	11

User Statistics

User Activity

SG-500-28P How to configure switchport port-security violation setting

VLANs with L3 Switch (SG-500)

SG-500-28P How to view mac address table?

I will give this a try. Thank

Thank you for your reply.Can

Thank you for your reply

VLANs with L3 Switch (SG-500)

VLANs with L3 Switch (SG-500)