I have 3x Meraki MS120-48 switches with 2x 2802i and 2x 1562d APs connected. DHCP is coming from a Cradlepoint router. The AP ports are trunks with native VLAN 3.  One of the 1562d APs will not pull an address, and the Meraki reports its address as 1...

I'm looking for the thresholds for operating temperature for this switch and can't find it anywhere. The data sheet gives specs for ambient temp, but that's all. show system and show environment all or show environment temp status don't give the info...

Is there a way to draw an obstacle on a Prime map and specify how tall it is? The situation is a building with a large outdoor walk-in cooler behind it. We are putting in outdoor antennas. I want to show how this cooler is blocking signal for antenna...

For authorization we have this line: aaa authentication login default group tacacs+ enable   The vty lines only have: privilege level 15 logging synchronous transport input ssh   The WAN connection to the router is down, so it can't reach tacacs. I ...

I have a question on choosing BGP timers.  I'm running two datacenter hubs with ASR1001-X routers, and 750-800 remote locations. The remote locations have two Cradlepoint routers each and roughly half have a mix of cable modem, DSL, and fiber/metro-e...