About Gaj Ana

Gaj Ana · 02-09-2016

Hi All We are implementing an ISE (1.4) and have come across the following issues regards to authentication order and a session termination after posture compliant. We got mab, dot1x as authentication order (authentication priority is set to dot1x...

Gaj Ana · 05-08-2014

Hi AllWe got few IP phones which uses lldp MED information to sent its system descriptions, type etc to the switch. These lldp med information can be seen in the Cisco switch, but when ISE does profiling using the snmpquery probe for these endpoints ...

Gaj Ana · 04-22-2014

Hi All In a windows environment where users have restrictions , do we need any special permission during byod supplicant provision or posture web nac agent or agent installs assuming active X/Java is already enabled? ThanksG

Gaj Ana · 04-10-2014

Hi All We have a distributed deployment where Alkatel ip-touch phones are authentictaed via MAB. Alkatel ip touch phones has 802.1x enabled by default and the phone tries eapol first and then switch authenticates via MAB which is fine. Once authentic...

Gaj Ana · 04-02-2014

Hi All In a distributed deployment where there is more than one PSN's how do we have a common url for guest redirection when doing a CWA (assuming no load balancer is used for the PSNs)? usually the redirection url would be 'https://<ise01.fqdn/guets...

Gaj Ana · 12-28-2016

Hi Jatin We had the similar issue. After enabling the above mentioned commands sensor seems to be working however cannot view the dhcp infor sent via radius accounting. Only cdp and lldp is sent. Have you seen this issue? Note we are running 3.7.3 c...

Gaj Ana · 09-13-2016

Hi Tom, We have a similar issue with any connect "Unexpected multiple mediaTypes in one linkStateNotification". We are using any connect 4.3. Did you find the cause or Solution to this? Thanks Gaj

Gaj Ana · 03-27-2016

Hi Ryan Sorry for my late feedback. Just thought to share with you or might be useful to others having a similar issue. Adjusting fragment size didn't work in our case for TLS. Following further wire shark debugs we found that F5 was setting the DF...

Gaj Ana · 02-14-2016

Hi Neno, Thanks for the feedback. Yes, We did implemented last week and doing further testing. Based on your past deployment any particular issues you have experienced (if any) when using this av pair with MAB, DOT1x authentication order? Regards ...

Gaj Ana · 02-03-2016

Hi Ali Did you able to solve the issue? Tks G

Member Since	‎09-09-2013 11:05 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	41
Total Helpful Votes Received	18

User Statistics

User Activity

Re-auth and switch port authentication order / session termination

cisco ise profiling -lldp med information

windows user permission for sup provision+nac agents

MAB/802.1x and Alkatel IP Phones

guest portal redirection with mulple PSNs

Hi Jatin

Hi Tom,

Hi Ryan

Hi Neno,

Hi Ali