johnny_5

johnny_5 · 07-10-2014

Please see below...Last configuration change at 16:18:21 UTC Thu Jul 10 2014 by adminversion 15.2ser...

johnny_5 · 06-20-2014

I'm guessing the unmanaged switch has dot1q enabled by default, the phones are working fine and are ...

johnny_5 · 06-20-2014

The phones do work and they are getting the proper IP address. We are upgrading to a new IP phone sy...

johnny_5 · 06-20-2014

Hi all,So I have 10 Cisco 7961's that were using power bricks which we replaced with a cheap POE swi...

johnny_5 · 04-13-2014

I posted the interface config???Here it is again,Thanks Fa0/31Switchport: EnabledAdministrative Mode...

johnny_5 · 04-13-2014

Connected to the switch on this port and many others are dumb terminals that communicate back to a s...

johnny_5 · 04-12-2014

I have read about the mismatch. First off how would that change? I mean there have been no issues fo...

johnny_5 · 04-12-2014

Hi Yes that command does work... sh controllers ethernet-controller fa0/31 Transmit Receive 11204154...

johnny_5 · 04-11-2014

Hi there,Yesterday all of sudden some of our machines(dumb terminals) could no longer connect to the...

johnny_5 · 03-26-2014

Thank you for the reply...The ASA is in a COLO(10.10.0.0/24 subnet) our remote locations include 192...

johnny_5 · 03-26-2014

Hi there, So i have been configuring a ASA5510 to the best of my knowledge to allow VPN access to ou...

johnny_5 · 03-14-2014

I have a Cisco 1242 AP with patch antenna attached(ANT2485P-R...2.4Ghz, 8.5dBi) placed on a wall tha...

johnny_5 · 03-12-2014

I wasn't in front of my pc when I last replied..I have included the sh flash...might explain it bett...

johnny_5 · 03-11-2014

As it happens I do have some more 1242's lying around. I did try and copy via TFTP the image from on...

johnny_5 · 03-11-2014

Thank you for the helpful info!So after reading some of the info on these links I need to TFTP a new...

Please see below...Last