I could get the config file from the router. I set my router as TFTP server and i use the Get to gra...

Hi , i encounter an error shown below while putting the notepad into the cisco router via tftp. The ...

currently I've a cable that plug to my desktop that is for Internet access. I have a switch and a ro...

So what must i do to test the SNMP traps without plugging out the fa0/0 interface?

Hi i don't quite get your question. my router only has 1 port connected which is the fa0/0 ip addres...

Hi i've configure my cisco router to receive the SNMP traps if the link goes up or down. However i f...

Hi i've configure my cisco router to receive the SNMP traps if the link goes up or down. However i f...

Hi i would like to do a program using SNMP Traps C#. Example if i plug out a cable from a router or ...

Hi Reza,all the computers in my lab has AV installed and firewall enabled. I tried the solution you ...

Hi Reza,May i ask how do i see is there any reset packet from my router using wireshark? I see. So c...

Hi Reza I'm using Symantec Endpoint Protection i've disabled all the anti virus as shown below but t...

Hi Reza!Yes i did not connect to my router now my router connectivity is up but i encounter another ...

Hi Reza i have downloaded the software but i keep getting the error timeout waiting block #1 i think...

Hi Reza Thanks for your reply and your kind assistance!I have already key in this command: tftp-serv...

Yes my router has snmp enabled.  May I know how I do using C#?