About subhankar.guha

subhankar.guha · 07-10-2014

C220-M3 (VIC1225) server integrated with UCS manager configured in Direct connect mode. Server loaded with RHEL over boot from LUN. I configured as of now eth0 vNIC only out of 6 vNICs with IP address from existing vlans. No error reported over Servi...

subhankar.guha · 09-24-2013

Hi AllI am new to UCS platform, I want to trunk multiple vsan in FI 6248 on single interface / portchannel. to upstream 5548 switch. From where to 2 different heterogenous storage.Request to let me know the possibilities, configurations or any recom...

subhankar.guha · 07-10-2014

yes the ping to the gateway is not working. I tried ping the RHEL server from the other servers which are of same vlan. but not able to do so.

subhankar.guha · 07-10-2014

the 2 Physical interface of VIC1225 are connected 1 towards FI-A and other at FI-B int 1/18 over FCoE cable. The interface had been configured as Server port to pass both FC and eth traffic, FC traffic is working fine as I am able to boot the server....

subhankar.guha · 07-10-2014

The RHEL OS eth0 interface is configured correctly. The eth0 vNIC at UCS end configured as Server port, but the mode is showing as unknown. if we enable/Disable the port the mode then comes up as Trunk but after server re-acknowledgement it is again ...

subhankar.guha · 07-10-2014

Thank Wdey for your reply.Your are absolutely correct on all the points you mentioned.The eth0 interface is tagged with multiple vlans and one of then vlan 999 is Native.How should I resolve the this issue

subhankar.guha · 09-24-2013

Thanks to both of youRelated to the above,if vsans are to run over FCOE, then is Trunking on that FCOE protchannel is autoenabled? or is there are other ways?Subhankar

Member Since	‎09-24-2013 02:27 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	10

User Statistics

User Activity

C220-M3 eth0 vNIC configured IP is not reachable

vsan trunk on 6248 uplink interface

yes the ping to the gateway

the 2 Physical interface of

The RHEL OS eth0 interface is

Thank Wdey for your reply

Re: vsan trunk on 6248 uplink interface