hello.
I understand that Connected routing has an AD value of 0.
The IP bands on the 1st and 2nd floors are different.
1st floor: 1.1.1.0/242nd floor: 2.2.2.0/24
There are two firewalls on top of the backbone.
The band will be 3.3.3.0/24.
If you conf...
Hi~ All
Some documents say that only Active-standby has a copy of the config.
Some documents say that all members have a config.https://community.cisco.com/t5/switching/what-happens-to-a-switch-s-config-when-it-is-removed-from-a/td-p/4469423
When rem...
hello
An additional VLAN 72 link has been connected between the Alteon L4 and the Nexus switch as shown in the photo below.
However, a loop occurred.
I connected, expecting STP to work for each VLAN, but the service was interrupted.
What on ...
I have a question about the Nexus Switch.
If I switch from a Nexus ACI license to NX-OS, will I be able to use features like BGP and OSPF?
Additionally, will I be converted to NX-OS Advantage or NX-OS Essentials?
Hi @Richard Burts
As shown in the topology below, traffic in the 2.2.2.0/24 band is directed to 3.3.3.1.
However, in the backbone, 1.1.1.0/24 and 2.2.2.0/24 are “connected IPs”.
And I also entered the ip routing command.
In this situation, communica...
M02@rt37 Thanks for the answer!
I have an additional question!
When you say switchports, are you referring to the ones where you can create VLANs when you put an Ethernet module on the router?
And when you say bridge domain, do you mean just add a br...