About Sinnathurai

Sinnathurai · 08-15-2014

Dear Experts, I'm looking for sample configuration documents for configuring QoS on Sup2T with IOS 15.1 SY.Cuold you point me to appropriate documents please. S

Sinnathurai · 08-15-2014

Dear Experts, I'm looking for sample configuration documents for configuring QoS on Sup2T with IOS 15.1 SY.Cuold you point me to appropriate documents please. S

Sinnathurai · 07-28-2014

Dear members,I want to know ifASA High Availability: one side with static ip addresses, other side with active/standby ip addresses is possible.(example inside interfaces on a HA pair with static IPs, outside interfaces with Active/standby , and wit...

Sinnathurai · 02-13-2014

Dear Team,I have an Aironet 1600 to setup without WLC.Aironet Hardware: AIR-CAP1602I-E-K9C1600 Software (AP1G2-RCVK9W8-M), Version 15.2(4) JA1, RELEASE SOFTWARW (fc1)I'm looking for documentation on1/How to get started for configuring using CLI as a ...

Sinnathurai · 10-24-2014

Port is configurable with QoS service policy.Unable to configure VLAN with QoS service policy.6506E-2T#!interface Vlan112 ip address 10.112.112.1 255.255.255.0end6506E-2T(config)#int vlan 1126506E-2T(config-if)#service-policy type lan-queuing input I...

Sinnathurai · 10-14-2014

Hi From the above URL The PFC3-based mls qos global command is replaced with the auto qos default global command, which is used for enabling QoS just at the port level and not at the PFC level7.2 Default State of Port Level QoS My question isAuto QoS...

Sinnathurai · 08-20-2014

6506-E, Sup2T, IOS 15.1(1)SY1==============================What are the Show commands to identifyWhat QoS markings arrive at the ingress port on core 6500-EWhat QoS markings set on egress port on core 6506-EWhat happen to CoS markings on egress? on i...

Sinnathurai · 08-20-2014

I've also used the following documents to prepare the configs.http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/15-0SY/configuration/guide/15_0_sy_swcg/qos_policy_based_queueing.htmlandhttp://www.cisco.com/c/en/us/td/docs/solutions/E...

Sinnathurai · 02-14-2014

I've found the answewr for conversion. 1600 AP specific: To load and activate IOShttp://techdom.nl/cisco/cisco-1600-2600-3600-ap-convert-lightweight-autonomous/

Member Since	‎09-26-2013 08:04 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	10

User Statistics

User Activity

QoS Sample configuration: Catalyst 6500-E

QoS Sample configuration: Catalyst 6500-E

ASA High Availability: one side with static ip addresses, other side with active/standby ip addresses

Cisco aironet 1600 standalone - How to

Port is configurable with QoS

Hi From the above URL The

6506-E, Sup2T, IOS 15.1(1)SY1

I've also used the following

Re: Cisco aironet 1600 standalone - How to