About ashu.desai

ashu.desai · 10-02-2013

Here's my Cisco version* Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M), Version 12.2(25)EWA14, RELEASE SOFTWARE (fc1)cisco WS-C4507R (MPC8245) processor (revision 10) with 262144K bytes of memoryProcessor board ID FOX0916024...

ashu.desai · 10-03-2013

There is no option except after the username is entered. So...SW4507(config)#username user2 ? SW4507(config)#username user2 priv 2 password cisco2 ^% Invalid input detected at '^' marker.I see that ...

ashu.desai · 10-03-2013

Strangely, this is what I found:SW4507#sh privSW4507#sh privilegeCurrent privilege level is 3In my "show run" too, it showed him as level 3. So I removed the user, added him again with level 2, and now the "sh priv" shows level 2.However, he still ca...

ashu.desai · 10-03-2013

Bob,Thank you for your help. I did a "no aaa new-model" and then went to the vty to do a login local. THEN it allowed me to change the input to SSH.I am finally good. As a bit of cleaning up and best practices, I have given a different username to an...

ashu.desai · 10-02-2013

OK so I am now able to get in, thanks to the CNA software!!!I made a few changes, took away the usernames, and entered username admin priv 15 secret xxxxxI am able to get in - however I have a few bugs.I still somehow get in on the User mode, and hav...

ashu.desai · 10-02-2013

No I don't. I am not sure about backup of the config. At this stage, without being able to get into the enable mode, is it possible for me to back this up?

Member Since	‎10-02-2013 08:38 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	10

User Statistics

User Activity

I am logged out after "enable secret" on WS-4507R

Re: I am logged out after "enable secret" on WS-4507R

I am logged out after "enable secret" on WS-4507R

I am logged out after "enable secret" on WS-4507R

I am logged out after "enable secret" on WS-4507R

I am logged out after "enable secret" on WS-4507R