Hi Kiley, You can see the utilization/reservation of the DSP resource using below command: show voice dsp group all Regarding your question, 1.  I would like to change the number from the other cluster to force it to choose G.729 and then dial in again to see what happens.  Is this possible? [Ans] You can configure a new region which communicates only G729 with all other regions. Then create a device pool, assign that new region to this new device pool. then assign this device pool to that device (from which you are making call). 2. One of my questions is:  is the number in this field specifically for SW conference resources or does it also apply to HW conference resources? [Ans] This is for both HW and SW resource. 3. if I use up all the resources on one DSP, it automagically "rolls over" to the next DSP resource but I can't really find this anywhere else.  Is this specific to the PVDM3-256 only? [Ans] No, this applies to all DSPs. During a call, you can see what dsp resources are being used by using below command: show sccp connection Hope this helps you in further understanding and fixing the issue. Regards, Piyush ... View more

Hi, In the output you can see that the NTP servers( 212.26.18.43  &  212.26.18.41 ) have stratum value of 16. Any stratum number that is above 15 is considered as unsynchronized. VG-KC#sh ntp associations       address         ref clock     st  when  poll reach  delay  offset    disp *~127.127.7.1      127.127.7.1       4    36    64  377     0.0    0.00     0.0 ~212.26.18.43     0.0.0.0          16     -    64    0     0.0    0.00  16000. ~212.26.18.41     0.0.0.0          16     -  1024    0     0.0    0.00  16000. If these ntp servers are within your network then you can change the stratum values between 1- 15. also you can refer this document. https://supportforums.cisco.com/docs/DOC-1263 Regards, Piyush Jain Please rate helpful posts. ... View more

Can you share the show run from both routers? Regards, Piyush ... View more