About Arturo Jr. Pacardo

Arturo Jr. Pacardo · 04-15-2019

Dear team, Good day. I have a question that puzzles me regarding my concern with our ISP. (Kindly refer to the attached network topology)My distribution switch, 2960X, is connected to three different WAN (ISP) that we have.port 1 is configured as acc...

Arturo Jr. Pacardo · 10-07-2013

Hello everyone,I am having a problem generating a new License Request from ELM.It was required to me by Cisco Licensing in order for them to provide me a new License file.Here are the steps that I made in generating a new License Request from ELM. (S...

Arturo Jr. Pacardo · 10-06-2013

Hello everyone,Good day!I was advised to configure IP Phones with DNs ranging from 1900 - 1999, it was said that those ext numbers were contracted to a Telco.Are those what they call "trunk lines"? From outside, you can call us via 622 + (1900 - 1999...

Arturo Jr. Pacardo · 10-02-2013

Hi everyone,Good day to all of you!I would like to know how to locate the Mac address of our Call Manager BE6K?The scenario is this. Our old CM has been replaced by a new one, now the new CM is on operation and the old CM is on standby, waiting to be...

Arturo Jr. Pacardo · 09-26-2013

Hello guys,Good day to all of you!I would like to ask if someone knows a certain topic or a link that would provide a step-by-step procedure on how to add a subscriber to a CUCM 9.1 BE6K?We would like to configure a subscriber as a standby fail-safe ...

Arturo Jr. Pacardo · 04-15-2019

@Jaderson Pessoa Hi! Thank you for your hasten response! Ok just to clarify.In my network, I have lots of VLANs, and each VLANs are routed specifically to where they would get internet access.- To answer your question, yes all of those VLANs are crea...

Arturo Jr. Pacardo · 10-08-2013

Hi everyone,Thank you so much for all the information that you have provided!If so happen that I bump into something new then I hope you guys would kindly help me again. Again, thanks and have a great day!Cheers,ArtNetwork Engineer Net Pacific Philip...

Arturo Jr. Pacardo · 10-08-2013

Hi mkchandak,Thank you for your response!Yes we did, we actually at first generated a license request, submitted it to licensing and they provided us a license file. Now, upon the installation of the license file we received this error message "Insuf...

Arturo Jr. Pacardo · 10-07-2013

Hi sir Chris,Thank you so much for your response.When I checked out the DN config of phones with direct lines (19xx) I saw that it has an input of 662XXXX on the "External Phone Number Mask" which I thought that 662 (company line) XXXX (4 digit direc...

Arturo Jr. Pacardo · 10-02-2013

Hello again Manish,Thank you for your response!Cisco asked for the PAK and the SO# of our device and hopefully from there they could track it for me.Thanks again and have a great day!Cheers,ArtNetwork Engineer Net Pacific Philippines CCNA R&S CSCO123...

Member Since	‎09-16-2013 12:00 AM
Date Last Visited	‎04-16-2019 04:06 AM
Posts	20

User Statistics

User Activity

Access mode port to access mode port with different VLAN each, possible to allow traffic??

Generate new License Request from ELM

Directory Numbers / Outgoing Calls

How to locate Call Manager BE6K mac address?

Adding a Subscriber to CUCM 9.1 BE6K

Re: Access mode port to access mode port with different VLAN each, possible to allow traffic??

Re: Directory Numbers / Outgoing Calls

Generate new License Request from ELM

Directory Numbers / Outgoing Calls

Re: How to locate Call Manager BE6K mac address?