hello experts,I have a site-to-site connection, currently I have a stabale connection from my LAN 192.168.1.100 /24 to far end LAN 192.168.55.1 /24, and now I need to add another LAN connetion from my current LAN to anew LAN from the far-end (I want...
hello experts,Just I have a quesiton, and much apprecicate if you can provide the answer.my question is; what is IP Planning / Operation department in GSM or SP companies?thanks a lot in advance.
hi expert,I have a cisco router and I use it for internet and VPNcurrently I have a internet access, but I don't have the VPN connection, I applied the correct configuration for the VPN.regards,
Hi Rick,I resolved the issue; first of all I missed to exclude the IP address from translation, secondly and from my customer ends they did a mistake in fonfiguring the ACL of VPN, I resolved by correcting both.many thnkas,
Hi Rick,you right, for many times I applyed sh run, but on last Thursday I was very busy next to this activity, so I forgot to check the NAT translation ACL. any way I do change all required points then I will let you know about the result.thanks,
Hello Rick,I have to exclude the new LAN IP address from the translation, I think I can apply this with in next week. once I changed the configueration I will let you know.currently flushing the SAs does not make any sense, because as you know there ...
hello Richard,thanks for your advice,regarding the platforms; my end I used Cisco 2921 ISR router and at the far end (my customer end) they have a JUNI router, also I have applyed translation on my end but I missed to exclude the new LAN far end in t...
Hello Bor Marton,this is my mistake in typing. in the real it is 255 and not 244. and from my end when I apply to the new far end LAN I don't have any reply. your advice please.thanks,
