About mcsadmin-cqgroup

mcsadmin-cqgroup · 10-09-2013

Hi Community,I have a Cisco 819G router which I've setup to use ADSL on the Dialer0/Gigabit0 interface, and 3G on the Dialer2/Cellular0 interface. I've setup a route-map on the VLAN1 interface to load balance the internet connections based on protoco...

mcsadmin-cqgroup · 10-10-2013

Hi Alain, I just tried the command "set interface Dialer0 Dialer2" under the route map and the results I found were:If I do a "show ip interface brief", dialer0 for the ADSL remains in status: up, line protocol: up, even though the underlying physica...

mcsadmin-cqgroup · 10-10-2013

Hi Alain, Thanks for your help. Although my next hop interface is dynamic in the case of 3G so I can't use this command. When I type "set interface dialer2" the only subsequent option is another interface. Does adding a second interface to this comma...

Member Since	‎10-09-2013 07:01 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	5

User Statistics

User Activity

PBR next hop interface failover

PBR next hop interface failover

PBR next hop interface failover