Fernando Patzlaff
Member since ‎04-15-2010

User Statistics

  • 27 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
CCP Member
10 Replies
5 Replies

User Activity

I've a FWSM in active/passive configuration, with 4.0.8 version of software without configuration of context. This equipament can support 256k connections.I want to limit this guy to receive at most 150k connections.I've read http://www.cisco.com/en/...
Hi everyone!I've two fwsm working in active/standby mode. I work with 5 contexts and I've 12 acl-partitions like these:FWSM/act/8/pri# sh resource acl-partition Total number of configured partitions = 12Partition #0    Mode            : non-exclusive...
I'm using two ASA 5540 in active-standby failover configuration. These boxes (primary and secondary) are used to establish some L2L and RA (Remote Access) VPN. The active box run OSPF process. The problem is when failover occurs (just shuting down th...
I'm trying to access my box ASA 5540 by https://ipaddress but I can't. I'm using Linux. I already have installed ASDM (when it works) and I can enter in the box by ASDM.The Mozilla show the message: "Error code: ssl_error_no_cypher_overlap".But I was...
Someone already seen the ASA inserting a wrong route in one connection that was established with it?  I'll explain more below: I've using a Reverse Route Injection. When a Remote Access with IPSEC (CLIENT) connects in the appliance ASA, the ASA crea...
Community Statistics
Member Since ‎04-15-2010 06:12 AM
Date Last Visited ‎10-09-2017 01:24 PM
Posts 27
Helpful Votes Given To