Hi all!
I know, yet another throughput question. But it is acutally not too easy to get these numbers and to pick a suitable router.
I recently ordered a brand new 400Mbps down / 20Mbps up cable connection with static IP. So I connected my 1941 to t...
hi all,i am using a cisco 1941 for my home vdsl connection. at this time i am using an external modem but i plan to replace it with the EHWIC-VA-DSL-B. i live in germany, so i require the annex b dsl over isdn variant of the ehwic. but before i make ...
Hi all,I am currently running a BERT test on an E1 controller. The "show controller e1 bert" command is showing no errors since I started the test (15 minutes ago).But I found out, that the serial interface associated to that controller is taking mas...
Hi Jim,
just saw that you put in another reply with the final answer. Thanks very much for confirming it. I still do not have vectoring support showing up in my region, but good to know that I'll be prepared for it.
Cheers
Felix
Thanks very much for your input.
The 210mbps on a 1941 is actually the reason why I am still digging deeper into this. Because like you said, it might be possible that I can squeeze more out of these Routers due to my "light" traffic mix.
But 3900 ...
I did some research on the web before I started this thread and indeed was quite sceptical that a 2951 could handle the bandwidth. Somehow I was hoping it would do it at least with NAT only and without any additonal services enabled.
But even if it ...
Hey Jim,
no worries mate. You reply when you have the time, that's alright.
If you say I am already vectorized, what do you mean by that? My provider would only need to activate it? So far they are not offering Vectoring and I have a bad feeling tha...
Hi Jim,I guess we both sit in the same boat then. I got my VDSL card in the meantime as well. So I am already quite familiar with the output you attached here. Right now I am not at home, but I will upload my stats as well later on. From my head I th...
