Hi, we have four Nexus switches 55K running nx-os 6.0(2)N2(5). The network is composed of two clusters of Nexus switches as shown below :
cluster 1 cluster 2
NX1_1 ---- VPC ---- NX2_1
| |...
We have put in service a catalyst 3850-12XS running ver 03.07.03E and we have noted that in certain ports, there is high output drops. Auto QOS is configured on this switch and we have tried removing the qos config on the ports having problem but it...
I would like to acquire 50Mbit/s Advanced license for csr1000v ver 3.10. I found the following license descriptions on the cisco website but I am unsure if they are the right ones. L-CSR-50M-IPB-1Y= CSR 1000V e-PAK 1-year subscription 50 Mbps IP...
I have InformaCast (v.9.0.1) and cucm v.10 running on my environment but when I make a broadcast to an active phone , the broadcast is sent to the headset. Is there a way or hack to have all InformaCast audio broadcasts' played only on the speaker...
The problem seems to have been solved by changing the order of steps carried out to change the vrf membership.
1. shutdown SVIs in all 4 switches
2. change vrf membership in all 4 switches
3. apply ip addressing in all 4 switches
4. no shut NX1_1 (s...
At first we thought the problem was caused by QoS , but after several attempts of fine tuning, we didn't notice any big change and the drops were still there. So far we still haven't got a solution from tac.
I believe it doesn't make sense to clai...
Here's the current output of the show interface ..
XXXXXX#sh int te1/0/1TenGigabitEthernet1/0/1 is up, line protocol is up (connected) Hardware is Ten Gigabit Ethernet, address is 00cc.fc68.f681 (bia 00cc.fc68.f681) Description: VLAN 599 XXXXXXX M...
Hi Leo, I am too stranded with the output on the interfaces.
Total output drops, output errors and Excess Defer frames on the sh_controllers output.
I am unable to explain why we have the errors on certain links.
