About Sylvain Brault

Sylvain Brault · 02-18-2014

Hi everyone,I have a 10 Mb link between two 2960 switch with two VLAN and want to configure the QoS to prioritise one VLAN (network 192.168.1.x)Here is the configuration on the switchs :Switch 1class-map match-any classIPC match access-group 10!!poli...

Sylvain Brault · 10-18-2013

Hey everyone,Pretty much at the end of the configuration of my VPN but I still have an issue. The VPN connection is up and the remote computer can establish a VPN with my router ( Phase 1 and 2 are ok) but I can not ping any devices from both sides. ...

Remote user IPSec VPN doesn't work · 10-16-2013

Hello,I try to setup a Remote User IPsec VPN on a Cisco Router 1921 but it doesn't work for a reason I don't understand. Does someone have any idea ? Did I forget something?Thanks in advance for your help!Here is a part of my configuration :aaa new-m...

Sylvain Brault · 10-15-2013

Hello,I use access list to close port on entry from internet but when I scan the port from internet, the port is still open (for instance 53 or domain). Does someone have any idea?I have a Cisco 1921 router on iOS 15.3Here is a part of my configurati...

Sylvain Brault · 09-25-2013

Hello everyone,I have 3 VLANs on the same interface and would like to block all the trafic between the VLAN 3 (Wifi access) and the two others ones VLAN 1 & 2 for security reason.As the routing is automatic between the VLANS on the same interface, ho...

Sylvain Brault · 10-22-2013

Thanks a lot Michael, it is working! Your inputs were very helpful, thanks again!

Sylvain Brault · 10-21-2013

Michael,I think there is something else wrong in my config because it is working on your side but not in mine...Here is my whole config, maybe you will see something...Thanks again for your time :-)version 15.3service timestamps debug datetime msecse...

Sylvain Brault · 10-21-2013

Michael, I truly appreciate your time and effort to help me. I changed the acl as below but still the same, the packets are bypassed.crypto isakmp policy 1 encr aes 256 authentication pre-share group 2 lifetime 3600!crypto isakmp client configuration...

Sylvain Brault · 10-21-2013

No it is 192.168.20.X

Sylvain Brault · 10-21-2013

No, I can't ping the router from the client and can't neither ping the client from the router. When i checked the detail of the cisco network connection of my client, the ip address is good - one from the IPPoolVPN - but the gateway is 192.168.10.1 r...

Member Since	‎09-24-2013 02:04 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	22

User Statistics

User Activity

QoS configuration on switch 2960

No traffic on the VPN tunnel but up

Remote user IPSec VPN doesn't work

How to close port?

Block trafic between VLAN on the same interface

No traffic on the VPN tunnel but up

No traffic on the VPN tunnel but up

No traffic on the VPN tunnel but up

No traffic on the VPN tunnel but up

No traffic on the VPN tunnel but up