About jaroslaw.mirek

jaroslaw.mirek · 10-15-2013

Hello, I have the Cisco 2811 router. When I switch it on i get:Upgrade ROMMON initializedprogram load complete, entry point: 0x8000f000, size: 0xcb80program load complete, entry point: 0x8000f000, size: 0xcb80program load complete, entry point: 0x800...

jaroslaw.mirek · 10-22-2013

After replaceing RAM (the new one, also DDR 400MHz 512Mb) i get the following (there are some small diffrence):System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 2009 by cisc...

jaroslaw.mirek · 10-15-2013

Hello Ashish,Thanks for your reply. I have downloaded new IOS image from cisco.com, this time it was: c2800nm-advipservicesk9-mz.151-4.M7.bin.Then I used tftpnld method based on link from you. Here is the output:rommon 1 > IP_ADDRESS=10.1.1.1rommon 2...

Member Since	‎10-15-2013 01:27 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	3

User Statistics

User Activity

Cisco 2811 doesn't start

Re: Cisco 2811 doesn't start

Cisco 2811 doesn't start