About Sunil Bhadauria

Sunil Bhadauria · 07-05-2016

Introduction OSPF External routers typically receives multiple paths for the same destination ip address. The OSPF External route selection algorithm decides which is the best path to install in the IP routing table and use to forward traffic . Re...

Sunil Bhadauria · 01-11-2017

Hello Sumit , you are right , that is the limitation and you will not be able to configure same vlan as source in different monitor session. However as workaround you could consider using individual ports as source in span configuration. Regards Su...

Sunil Bhadauria · 06-19-2016

Hello Fbloss100 I believe i misread the problem statement and so correcting my response as well . Sounds like below is the concerned configuration : l2vpn pw-class test encapsulation mpls preferred-path interface tunnel-te 1 ! ! bridge g...

Sunil Bhadauria · 06-16-2016

Hello, It is CPPr . In ACL-COPP-CATCH-ALL acl you are already matching all ip , tcp , udp and ICMP traffic. Anyways , i understand your query is "what kindly of traffic will hit default class then" . Non-ip traffic = eg , arp , l2 broadcast and o...

Sunil Bhadauria · 06-16-2016

Hello Vaibhav , Thanks for reaching out to Cisco Support Forum . Kindly let me know : What platform ? What module ? What code ? show hqf inter <> complete QoS service-policy configuration ( including child policy) HTH Sunil

Sunil Bhadauria · 06-15-2016

Yes , that should work . However you may want to recheck on whether you want to use "bandwidth" or "priority" keyword under policy-map . that depends on what you need . if you want this traffic to use specifically only 20MB and not more than that ,...

Member Since	‎10-23-2013 04:29 AM
Date Last Visited	‎02-16-2018 03:56 AM
Posts	49
Total Helpful Votes Received	73

User Statistics

User Activity

OSPF External Route selection algorithm

Hello Sumit ,

Hello ,

Hello,

Hello Vaibhav ,

Yes , that should work .