HIDoes anyone have an information on IPC dealerboards? I am unsure how these terminals connect to the cisco and PSTN, some seem to use analogue lines direct other seem to have E1 / T1 cards - can you register them on cisco?thanks for any info- got a...
I have a CM8,6 , CUP and Lynca user has a phone number on CM with a remote destination of the lync client. is there a way to link the presence information from MS Lync back to the cisco phones and vice versa using CUPs and Lync?
hi, do I need to open the full UDP port range, 16384 - 32767 does CM and phones use every port in this range or could I reduce it to say the first 500 , does it look for the first open port?whats the impact of reducing this?
hiI am using CUPS 8.0 and when I try and transfer a call to my Remote destination I get "Mobility Failure"This works ok from standard phones and cucimochave I missed a setting?
HiI am using remote destinations with mobile connect to a mobile number. I have noticed when some one dials my line and the call comes through to my mobile if I cancel it or divert it to voicemail the call will continue to ring the RDP line until the...
I have seen this also. you have to be logged into the deskphone when the call was made other wise you can't transfer back from the remote device to the desk phonethis must be a fault as its the whole point of mobile handoff
hithe problem is I need to have a phone button template for a 7960 for the lines. so you can't add the mobility key to this type of device profile. I added the phone button template to the 6900 with mobility enabled but when my user logs in with thei...