kbillingham
Level 1
Level 1
Member since ‎10-18-2013
‎08-18-2017

User Statistics

  • 12 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hello,I configured an ASA5512 with the integrated IPS software module. I am having issues connecting to the software module. The IPS software module is running and I have configured it for the same subnet as my inside interface. When I click on the I...
Hello, I have one 48 port SGE2010 and one 24 port SGE2000P at separate sites that are connected with single-mode fiber. I was wondering if the SGE's will support 10gb Mini GBIC transceivers or only 1gb Mini GBIC transceivers? I would like to connect ...
Hello,I am trying to configure CUPS (version in title) in a new LAN segment. I will be using CUPS to run Jabber. I am stuck on the post install setup. What exactly should I be using for the AXL username and password? I know I did set a password for n...
Hello,I am somehwat new to Cisco and routing. I have an installation of two ASA 5505's that are setup for site-to-site vpn as well as AnyConnect. The AnyConnect subnet can connect into the inside vlan at SiteA but I cannot get to the remote subnet at...
Hello,I have configured AnyConnect to use a 10.0.7.0/24 subnet for it's DHCP pool. I can connect to the ASA just fine, but I cannot access any internal services on my 10.0.5.0/24 subnet which is my INSIDE interface vlan subnet. I have setup a NAT exe...
Community Statistics
Member Since ‎10-18-2013 01:02 PM
Date Last Visited ‎08-18-2017 04:27 AM
Posts 12