Member since ‎10-04-2013

User Statistics

  • 30 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies
20 Replies

User Activity

hello everyone,                     i have a 2960 compact  switch. i wanted to know whether its possible to make this switch transparent. the requirement is that whenever the switch is connected to any lan, it should be able to access the lan without...
hi everybody,                  we have a print server 2008r2 set up in our network, and the shared  path is \\\printer.the printer ip is all other access rules are working fine except the one highlighted below in red. we want...
hi guys,       i have a ghost story to share..  i had configured some access lists in my 3560 switch and after testing  everything was working fine. then i had powered off the switch after saving the config. today when i powered it back on, i saw two...
Greetings,            i have 12 vlans configured on a 3560 L3 switch and this is trunked to  7 L2 2960 switches. this stack is in a different block. i need to route all these vlans to another core switch from which it will going to firewall and throu...
hi ,           i have a dhcp server 2008r2 with ip in vlan 3. wanted it give out IPs to vlan 2 and 6. when i apply the access as shown in the config , it does not work. i then tried adding the access list ip access-group 102 out later on ...
Community Statistics
Member Since ‎10-04-2013 12:01 AM
Date Last Visited ‎02-08-2021 03:38 AM
Posts 30
Helpful Votes Given To