About m.efstratiou

m.efstratiou · 10-23-2013

Hi all,I am trying to create a site-to-site IPSec tunnel between ASA 5510 and 1841. The ASA has already one with another remote site that it works. Below is the relevant configuration1841====crypto isakmp policy 13encr 3deshash md5authentication pre-...

m.efstratiou · 10-29-2013

Both commands already exist in the configuration

m.efstratiou · 10-25-2013

Regarding the internet traffic, do you refer that the default route should be to the dialer? I changed it to ASA when I removed the nat of 1841 in order to have access from the HQ. I did put again the dialer but there is no access.Below is the debug ...

m.efstratiou · 10-25-2013

Regarding your remarks:1. The tunnel should be up no matter who initiates the traffic, it should be permited the remote site to make a request2. For the internet traffic I created to the ASA the PAT-8 that I attached. Moreover, I put the any to the ...

m.efstratiou · 10-24-2013

My last config is as follows:1841====crypto isakmp policy 13 encr 3des hash md5 authentication pre-share group 2!crypto isakmp key address !crypto ipsec transform-set TEST_SET esp-3des esp-md5-hmac!crypto map TEST_MAP 13 ipsec-isakmp set peer set ...

m.efstratiou · 10-24-2013

I believe you are reffering to the first line of my statement of access-list 110. The network that I tried to ping was on the 10.0.X.X subnet, but I made the change you suggested anyway and it does the same. The traffic should initiate from ASAMore...

Member Since	‎10-23-2013 12:57 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	7

User Statistics

User Activity

IPSec ASA-1841

IPSec ASA-1841

IPSec ASA-1841

IPSec ASA-1841

IPSec ASA-1841

IPSec ASA-1841