I have installed FMC and registered 2 SFR module successful.
I have also configured ASA to send traffic to SFR for traffic analysis but still I am not able to see any traffic on FMC being analyzed.
Below is the ASA config :
ASA/act# show service-p...
Hi Team,
I have Cisco ASA and earlier it was having local users without AAA enabled. So we have admin users and few Read-only user.
Now I have configured AAA with Radius server on it. And my users are added on Radius server to authenticate.
Issue is ...
Hi Support, Can I get the procedure to upgrade the firmware of leightweight AP 2702i firmware to its latest version of leightweight firmware.All I am getting is the Leightweight to Autonomous procedure which I dont require. Regards,Ninad Thakare
Hi Support,I have configured the ASA CX and configured the Web filtering policies.In the policies, I have created the user objects for each of my user with their IP address for the Source. But I need to integrate it with Active Directory which will b...
Hi,I have an ASA 5515-X with 9.1 version.Where I have created 5 sub-interfaces in my 0/1, with individual subnets whereas Firewall is Gateway to my user.0/0 - outside - WAN0/1.1 - inside16 - 172.16.16.1/230/1.2 - inside30 - 172.16.30.1/240/1.3 - insi...
Hi Marvin,
I have set Intrusion Policy to "Balanced security and connectivity" and logging with "Log at end connection" for Allow traffic and "log at beginning of connection".
Hi Rasika,Its an new installation and working on isolated network not on production.where as we dont have NTP server and not able to configure time on WLC. But we have matched same time with AP and WLC.Attached file consist of required info. Regards,...
Hi Leo,Thanks for the reply.Actually we are facing the AP registration with WLC showing an error which is enclosed in an attachment even though the AP is getting the DHCP IP from WLC and also able to ping.Hence we thought for upgrade the Lightweight ...
