Frank Heinig
Cisco Employee
Cisco Employee
Member since ‎10-16-2013
‎11-21-2023

User Statistics

  • 5 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 35 Helpful votes Received
Recent Badges
 30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
Certifications

User Activity

6PE OverviewThe Cisco 6PE solution enables IPv6 domains to communicate with each other over an MPLS IPv4 core network. MP-BGP in the IPv4 network is used to exchange IPv6 reachability information along with a label for each IPv6 prefix announced. 6PE...
CRS-1 and CRS-3 short recap The reader of the following article should be familiar with MQC and the corresponding CLI on CRS-1 and CRS-3.  The QoS implementation on CRS-X follows the SSE architecture on the LCs. QoS components on CRS-X are not shared...
Overview Power management support was introduced for the CRS platform from IOS-XR version 4.3.0 onward.The implementation includes the tracking of the available power to the chassis and the power consumed as well as chassis power zone monitoring for ...
The nominal input voltage of the modular DC power-subsystem on NCS6k is -48 VDC or -60 VDC. It accepts an input tolerance in the range from –40 to –72 VDC. Alarms are generated if certain thresholds are crossed. Minor: -44VMajor: -42VCritical: -40.75...
The modular (arctic) power-subsystem accepts input DC power in the range from –40 to –72 VDC. Alarms are generated accompanied by a corresponding syslog message if certain thresholds are crossed. Minor: -44VMajor: -42VThe following example displays a...
Community Statistics
Member Since ‎10-16-2013 06:32 AM
Date Last Visited ‎11-21-2023 04:16 AM
Posts 5
Total Helpful Votes Received 35
Helpful Votes From