Hi,
I have done this a few times and am missing something but cant figure out what it is. I think I should have set Gi2/0/1 with trunk for Vlan 1 & 50 - it shows no trunk at all.
Any ideas what i am doing wrong?
Thanks, Rich
Booting off of: c2960...
Hi,
I am using PFsense as a router & setup a vlan 50 - i am looking to put 3 WAPS on Vlan 50 - to keep my kids off my work computers network.
I setup the Pfsense Vlan I followed a youtube video. End result is having PFsense give an Ip for Vlan 50 o...
Hi,
I have a SG200-26P and was looking to get it to the latest firmware.
I am able to get it to 1.3.7.18 but it keeps saying the files are too big after that update.
If i try to go past it with any of the files I get this message:
Upgrade/Back...
Hi,
I have a SG500-28P switch & have had it for a few years. I am noticing that periodically it loses its static IP, password, etc. Just reverts to a factory setting. i have reset the unit 5 times over the years. I am using POE (about 20% usage)...
Hi,
I am looking to make take a template from SPA504G #1 and using the TFTP protocol using hte config file to send to SPA504G #2.
I used the file here:
http://192.168.168.199/admin/spacfg.xml
then saved as a cfg file.
How do i send that config...
User Access Verification
Password:Switch>enablePassword:Switch#sh interface gi2/0/14 controlGigabitEthernet2/0/14 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, address is e840.405c.3e8e (bia e840.405c.3e8e) MTU 1500 byte...
I sometimes replace phones that are wall mounted. Is there a way to edit the XML file to give it a generic mac - I read something about using : $MA
Original config Mac:
<Host_Name group="Info/System_Information">SEP7081053CAA12</Host_Name>
Gene...