About itm-network-support

itm-network-support · 06-11-2014

I have a VLAN with an ID of 140.This VLAN works perfectly across the network. It is trunked to multiple access switches, through our 5548's, and also into our Wireless LAN Controller(5500 Series).I want VLAN 140 (10.10.140.0/24) to be completely isol...

itm-network-support · 06-04-2014

I have 2 Cisco 2960'sThere is no router (default-gateway) and there will never be. These two switch will connect our security networks between buildings.I have a trunk port that connects the switchesThe switches can ping each other just fine.Switch1 ...

itm-network-support · 05-29-2014

I have a stand alone C3560 with the below setup.The client has 10.10.200.3. I am connected into port 48 and have the CLI up on the console port.I have no gateway to connect to.I am just trying to upgrade the IOS software to begin setting up my config...

itm-network-support · 06-12-2014

It is 5548 and the VLAN Gateway is 10.10.140.1.I know 'where' to configure it, I was hoping I was on the right track with setting up Private VLANS to accomplish this. Also, does the 5500 WLC allow configuration to be included into the PVLAN?Are you s...

itm-network-support · 06-12-2014

Thanks for responding.I want the clients to be able to talk to each other in VLAN 140. but I want the VLAN 140 to be isolated from all other VLANs.

itm-network-support · 06-06-2014

Well you guys were right.It was a toughy. I was unaware that our Trend Micro had settings built in that when being connected to certain IP scopes, that ICMP blocking would apply.It was for laptops that when outside of out network would connecting to ...

itm-network-support · 05-30-2014

Thanks for the help. I used ROMMON to get the newest update. Nothing I tried would let me pull the bin from the TFTP server.

itm-network-support · 05-30-2014

Switch#sho int vlan1Vlan1 is up, line protocol is up Hardware is EtherSVI, address is 1005.caa3.dac0 (bia 1005.caa3.dac0) Internet address is 10.10.200.2/24 MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxloa...

Member Since	‎11-20-2013 11:29 AM
Date Last Visited	‎04-05-2024 12:24 AM
Posts	13

User Statistics

User Activity

Configure Existing VLAN on Wireless Lan Controller to be in a Private VLAN

Two 2960's Ping each other, but clients connected can only see switch

C3560 and One Client. Can't ping the client from the switch

It is 5548 and the VLAN

Thanks for responding.I want

Well you guys were right.It

Thanks for the help. I used

Switch#sho int vlan1Vlan1 is