Hi,
We installed CML 1.2 and successfully licensed the CML_CORPORATE and CML_CISCO_VM_CAPACITY features; everything's working quite fine.
We also purchased 1 x L-CSR-10M-SEC-3Y= SKU, and before applying it we would like to better understand how thi...
Hi,
I installed, for the client I am working for, CML v1.2.
Performing the first setup according to the Cisco Modeling Labs 1.2 User Guide, we specified in UWM --> CML Server --> System Configuration --> Networks tab, the FLAT-FLAT1-SNAT subnets info...
Hi,
I'm facing the setup of an Office Wireless LAN with two Cisco WAP551 Access Points.
The two access points will be connected via PoE to a Cisco SG200-26P, that is also connected to wired devices and the internet router.
The final customer is also ...
Hello, I have a pair of Nexus 7000 (NX-OS 6.2) in vpc domain, each of them equipped (in a vDC different from the admin one) with a Nexus 2248TP FEX.On the two fex I created a 4xGbE vPC (2 ports on each FEX) connected to an EMC DataDomain device, that...
Hi,we have a small network built on 4 Cisco Nexus 5596UP in a full meshed topology for layer 2 traffic only, to interconnect different servers that needs to exchange clustering information between them.On Nexus 5000 switches it has been enabled Fabri...
I could finally find the source of the problem.
With a better analysis of the rehost process output, I could notice the following error (the same for SNAT, FLAT and FLAT1 subnet creation):
ID: create snat subnet Function: cmd.run Name: ne...
Thanks againg Steve for your support.
Unfortunately the suggested procedure doesn't solve the problem.
During the rehost process we could notice that several times the correct information about networks are listed; here it is an example extraction of...
Thanks for the answer.
Attached to the post you can find a copy of a project file we can not simulate, but consider that the error happens with any kind of topoplogy, even with a single IOSv router.
The CML Server is a Virtual Machine running on ESXi...
Thank you for your suggestion Philip.
Unfortunately what I listed before is the only equipment available at the customer office, and the goal is to bring wired and wireless connectivity in the office just with that one.
Anyway, on the WAP551 datashee...
