Hello again, Im stuck This is what I have done. I have created the vPC between my esx host and my two nexus 5000 switches, but it doesnt seem to come up: S02# sh port-channel summary Flags:  D - Down        P - Up in port-channel (members)         I - Individual  H - Hot-standby (LACP only)         s - Suspended   r - Module-removed         S - Switched    R - Routed         U - Up (port-channel)         M - Not in use. Min-links not met -------------------------------------------------------------------------------- Group Port-       Type     Protocol  Member Ports       Channel -------------------------------------------------------------------------------- 4     Po4(SD)     Eth      LACP      Eth1/9(D) ###################################################################### vPC info: S02# sh vpc 4 vPC status ---------------------------------------------------------------------------- id     Port        Status Consistency Reason                     Active vlans ------ ----------- ------ ----------- -------------------------- ----------- 4      Po4         down*  success     success                    - ####################################################################### vPC config: interface port-channel4   switchport mode trunk   switchport trunk allowed vlan 20,27,30,50,100,500-501   spanning-tree port type edge trunk   vpc 4 interface Ethernet1/9   switchport mode trunk   switchport trunk allowed vlan 20,27,30,50,100,500-501   spanning-tree port type edge trunk   channel-group 4 mode active ######################################################################## Im unsure what I must configure on the cisco 240M3(esx host) side to make this work. I only have the two default interfaces(eth0 and eth1) on the vic-1225 installed in the esx host, and both have the vlan mode is set to TRUNK. Any ideas on what I am missing? Message was edited by: HDA ... View more