Ahmed Ayaad
Level 1
Level 1
Member since ‎11-18-2013
‎08-02-2023

User Statistics

  • 91 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 10 Helpful votes Received

User Activity

Dears, i have ucs c 220 series and contained 2 power supply their Firmwares not the same. So, i need any method to can upgrade power supply firmware to be same. Thanks,
Dears, I have switch down in my network and when i need to take the configuration from configuration archive tab i found all devices can access it but i can't access the down switch it was dimmed and can't open it to get the configuration archived b...
Dears, we have WISM2 and configure it with option 82 on DHCP & Interfaces as shown on attached to send AP-SSID through dhcp. I want to know which debug i will do on WLC to see option 82 on the dhcp request, as i tried (debug dhcp packet enable & de...
Dears,  I have WISM 2 and try to configuring the syslog server for Access points  with the below command. config ap syslog host global syslog_server_IP_address But i found all APs communicate directly with syslog server & creates syslog host for each...
Dears, i have a problem with Cisco prime infrastructure 2.2 (CPI) is that send huge number of email notifications for switches ports (Down or Up). When i edit configuration of switches & switches and hubs from severity critical to severity minor act...
Community Statistics
Member Since ‎11-18-2013 08:34 AM
Date Last Visited ‎08-02-2023 12:02 AM
Posts 91
Total Helpful Votes Received 10
Helpful Votes From