Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am unable to configure SSO server in Prime by IP and DNS any help would be appreciated here.
errors which are reflecting on Prime.
1. Error With SSO server IP
(Error : Error importing certificate from SSO Server: Connection refused (Connecti...
Hi
My Vti is not coming up in ASA connected with ASR router i am testing it in LAB.
Any expert comment would be appreciated
asa# show interface tunnel 100Interface Tunnel100 "vti", is down, line protocol is down Hardware is Virtual Tunnel MAC add...
Hi Friends,
I am new to PIX firewall and need one help i have configured remote access VPN on PIX firewall but when i am trying to access from VPN client its not working and reflecting error remote peer is no longer responding. Attaching Config for ...
Hi Friends, I have v4 mpls working fine but v6 refuses to work correctly. Looking at the ipv6 routing table for the VRF we can see prefix's coming from the remote PE's BGP is up in vpnv6 and ipv6 unicast. Everything seems fine but I m unable to ping ...
Hi All,Please help i have 9 routers in my project R1,R2,R3,R4,R5,R6,R7,R8,R9 WHERE R1,R7,R8,R9 are CE routers & rest are PE routers.i want to redistribute RIP into BGP & below are config.of CE(R1) & PE(R2) as i run show ip route in R1 then unable to...
Hi Richard,
Thanks yes i was missing tunnel group for VTI and it up now and exchanging routers properly through BGP.
But I am unable to build adjacency with ospf over vti is there any chance of ospf support above 9.7ASA versions.
Hi Husycisco,
I am also testing VTI in ASA5515(9.7(1)4) and other end is ASR1000 (03.16.06b.S) but my VTI is not coming up any expert comment would be appreciated if anything i am missing.
Config at both ends as per below.
asa# show interface t...
Hi Marius,
Issue has been resolved initially i was doing wrong config in VPN client
i was creating certificate in Pix firewall and at VPN client end i was using authentication user name And password so it was wrong.
Now I have created Pre-shared ke...
my pix is 515 with version 8.0(4) and having NAT-CONTROL enable.
does below nat give issue to connect VPN ?
global (wan) 1 interface
as VPN users are coming from wan interface. Thanks.
