We have an ASA 5510 with dual ISP. The default route is configured to ISP1, and the inside clients are goes also to ISP1. We have a DMZ interface, there are public servers in it with private IP, the interesting ports are forwarded to them. The public...
Hello,i have a problem with a single port forward with 9.2 ASA (5505). Here is the related config.: access-list outside_access_in extended permit icmp any anyaccess-list outside_access_in extended permit tcp any host 10.168.50.5 eq www logaccess-list...
Hi,we get an NCS Applience with 1.3 sw, and my first thing was to upgrade it to PI 2.0. The problem is that now the ncs service can't start, and i cant open the gui webpage. If i try to start the service, it says "This may take a few minutes..." but ...
Hi!I had a problem, we hav 10+ WLCs in 2 mobility groups, but managed by one NCS. If i make a report about the rouge APs, it contains the APs from the other WLCs also from the other and the same mobility group. How can i make it that the report not i...
But it seems yes :).I moved this back to section 1.:nat (Guest,outside) source dynamic obj_any interface The object is.:object network obj_any subnet 0.0.0.0 0.0.0.0 I think i should specify it more.
I think about the inside VPN NAT rule, the DMZ VPN rule was moved earlier to section 3. One of these rule matched before the port forward.:nat (Guest,outside) source dynamic obj_any interfacenat (inside,outside) source static any any destination stat...
