Hello, I am working with CUCME and Busy Lamp Field (blf).  I am using all SIP phones (8861).  I am getting inconsistent results for the busy lamp and I'm not sure why.  Sometimes the lamp lights, but not on every phone that's watching.  Sometimes the...

I have a 1941 that has high CPU load from interrupts with no traffic.  I started out with a clean configuration and it is running IOS 15.8(3)M7.  It has about 89% CPU usage even without traffic, but it's almost all interrupt.  It has a very simple co...

Hello,I am trying to get the internal access point in a 1941W to work.  I didn't have the original configuration, so I reset the configuration on the 1941W and got that going.  For the internal access point, when I connect to the console and try to l...

Hello, I just set up a Cisco access point with autonomous IOS firmware, and I am having problems with Apple iPhones.  After some period of time, the 802.11 no longer works, but the Apple device says it's still connected.  It doesn't work again until ...

I am using CME/CUCME 12 and 8861 phones with 12.6.1.  The blf functionality works for a while, and then stops working.  Lights are off when a line is in use, and on others sometimes don't go out after someone hangs up the call.  Rebooting the phones ...