Matthew burnley
Level 1
Level 1
Member since ‎12-13-2013
‎01-20-2021

User Statistics

  • 53 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 20 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Hi, If a port goes down on  a cisco switch is it possible to pass the port down state through to another port to take the line protocol down?  I have an issue where an upstream failure needs to be detected on the internal side of the network on the s...
Guys, Im debating buying a 5548UP for a home lab setup - i want to connect it to my ASA5515x but that only supports 1Gb copper ethernet.  Does the 5548UP support 1Gb copper SFP's or just 10Gb?  Ive checked the spec sheets but its just not clear to me...
Hi all, I’ve been reading up and SPAN and the use of aggregator taps and full duplex taps.  I feel i have a better understanding of each, but i still have a question that cannot seem find the answer to, hopefully somebody will know the answer to this...
Hi all I have an issue i hope somebody can help me with it.  I have a DMVPN setup i am labbing so far with only a single spoke and a hub, at this point the tunnel comes up and EIGRP forms on the hub, but not the spoke.  The Hub and spokes are behind ...
Hi all, I've searched the internet high and low and cant find a definite answer to this one.  With the old ASA's with the firepower modules is CTR+PROTECT licenses enough for the IPS to work and generate IPS events in the event viewer (adsm) or FMC? ...
Community Statistics
Member Since ‎12-13-2013 08:33 AM
Date Last Visited ‎01-20-2021 01:26 AM
Posts 53
Total Helpful Votes Received 20
Helpful Votes From