About claude1966

claude1966 · 12-13-2013

Hello everyone,I would like to verify what is the actual boot image running on my catalyst 6503 E SUP 2T.My IOS is s2t54-adventerprisek9-mz.spa.151-2.sy.bin and my Rommon is ok with the version 12.2(50r)sys3.I tried many command without any success....

claude1966 · 12-18-2013

THanks again for your help !I was confused because I heard that the Rommon image, the image you refered to( V12.2(50r)SYS3)is not the same as the Boot image that I refered before (s2t54-boot-mz-spa...).Claude

claude1966 · 12-18-2013

Thanks for your answer !So, no command exist to verify what is the version of this image tha running on my router: s2t54-boot-mz.spaxyzSY.binI can only verify the image save under the flash with the command (dir) and I can verify what is configure u...

claude1966 · 12-13-2013

I am looking for the boot image and not the system IOS image . The boot image is a smaller version of the system IOS image that can be use for TFTP or access the switch if the IOS is corrupt.Her's my two file under my flash:1. IOS Image : s2t54-adv...

claude1966 · 12-13-2013

If I do dir bootdisk: I can see the boot image (s2t54-boot-mz.SPA.151-2.SY.bin) stotre on my flash, but I can not be sure tha's the one running !I would like to verify the one that is runningThanks!

Member Since	‎12-13-2013 04:52 AM
Date Last Visited	‎02-08-2021 07:31 PM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

What is the show command that i can use the see the actual boot image on my catalyst 6503 E

What is the show command that i can use the see the actual boot

What is the show command that i can use the see the actual boot

What is the show command that i can use the see the actual boot

What is the show command that i can use the see the actual boot