Hi,I have the following configuration using a CCM 4.0 and a cisco 3725 GW (with two E1):PBX-Gateway-PSTN.Everything work fine except calls to the PSTN from phones that are connected to the PBX. The call lasted 4s and disconnect.RQ: the calls between...
Having no DVD-Drive on my HP Proliant DL320 Server, I actually can't install the Cisco Certified Operating System.What could I do to pass over this problem ?Thanks, Guillaume.
Hi,When a customer make a call, i want some phones to ring (3 times) and if there is no answer, a welcome message is played while the designated phones are still ringing.I have CCM 3.3.3, AA installed, and Cisco 2651XM as the gateway.
In a voip migration stage, we connect a matra pabx to the pstn trough a cisco 3725 (with two E1) using QSIG on pabx side and net5 on the pstn.we saw (debug ISDN q931) all the messages coming back and forth and making the call, we did hear the phone r...
Hi,Thanks for your replies.I've already configured the "isdn protocole-emulate network" on the serial interface connected to the pbx.I think the problem could be related to Timers ...Yes, calls between IP phones and PBX-phones are working in and out...
Yes, i'm trying this solution.I modify the greeting message, but i want the default script to go directly to the operator after the message was played, so the customer don't have to press anything.
Thanks a lot for your replies.Yes, there is an aim-voice-30 installed and the problem was due to the misconfiguration of the aim clock interfaces. The following commandssolved my problem."network-clock-participate wic n" "network-clock-participate ai...
Thanks a lot for your replies.Yes, there is an aim-voice-30 installed and the problem was due to the misconfiguration of the aim clock interfaces. The following commandssolved my problem."network-clock-participate wic n" "network-clock-participate ai...