PACC
Level 1
Level 1
Member since ‎12-11-2013
‎12-11-2023

User Statistics

  • 41 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Hey all,Have a BE6000 running esxi 6.7.0 for CUCM.  The Link Discovery Protocol option only has CDP.  The BE6000 is currently connected to a Cisco C9300 switch, but I want to connect it to an Extreme 3750.  I enabled CDP on the ports on the Extreme 3...
Hi all,I'm trying to create a port channel from an EdgeSwitch 24 to a Cisco 9300, but after testing by connecting just one cable I don't get any connectivity between them. The arp table on the 9300 shows the IP address of the edgeswitch but an incomp...
Hi all,After successfully moving two C9300 stacked switches without powering them off or affecting the network... we had a power event which forced them off Anyway, they powered back up ok and everything is running except a strange issue with the 10g...
Hi all,Simple question!We have two C9300 switches that are stacked.  We want to physically move the switches with minimal downtime (they are doing all our layer 3 stuff).Switch 1 (active)Switch 2 (standby)There are currently only 12 ports being utili...
Hey allRunning Unity Connection 11.5.1.12900-21 with CUCM.I have a one-off holiday schedule set up for when we have staff briefings so our phones are forwarded to our out-of-hours phone service. Our timezone is currently Australian Central Daylight T...
Community Statistics
Member Since ‎12-11-2013 03:49 PM
Date Last Visited ‎12-11-2023 04:57 PM
Posts 41