Hello again,I have some questions on how to have multiple NATs or PATs.   I have a list of IP addresses that I want to allow incoming to receive emails through SMTP (Emails go to our SPAM service, then we only allow incoming emails from that service)...

Hello everyone!  So, I'm going from a Cisco 891 router to a Cisco 3925 router with a built in T1 card.  The 891 had a switch card so I could use all sorts of Layer 3 switch commands YAY!  But the new 3925 (wholly huge batman) does not.  So, I'm not u...

Setup my WAP321 this morning.  Unplugged network cable.  Walked across the street, plugged in for deployment, dead.  Tried POE from switch, from injector and even plugged power cord in, nada.  How do I get it serviced?  We just bought it 1.5 months a...

We have an ASA5505 and we are unable to get passive ftp to work from outside our system to inside.  Active FTP works, but not passive.   Passive works inside our organization so the issue isn't the server itself.  Below is my configuration:!hostname ...

I'm quite new to the whole cisco thing here.  I am very hesitant to make changes as I'm not 200% certain I won't bring down the whole network. (We are a very small company)We have a cisco 1811 router (yes I know its old)Now we have a route map and I ...