About Sandeep Verma

Sandeep Verma · 10-24-2015

Hi everyone,I am trying to change the attribute of a summary route using attribute map. The attribute of the summary gets modified but the prefix is not being advertised to direct eBGP neighbor. route-map abc permit 10set community no-export router ...

Sandeep Verma · 08-31-2015

Hi Friends,Need some of your thoughts regarding this scenario. I have a WAN1 CE router running BGP as exterior protocol and ospf as internal (With core switch). I have redistributed the static default route into core switch ospf process and the WAN1...

Sandeep Verma · 08-20-2014

Hi, I have 2600 series AP registered with 2504 WLC over WAN working in Flexconnect mode. All of a sudden the AP lost connectivity to WLC and is operational in Flexconnect mode now.I am concerned whether it should rejoin again automatically ?(which di...

Sandeep Verma · 08-20-2014

Hi All,Recently deployed Cisco Catalyst 3850-48P-E Stack Switch. I am receiving a lot of syslog messages ''''Controller port error, Interface Gi3/0/28: Power Controller reports Short detected''''Switch Software version : 03.03.02SE RELEASE SOFTWARE...

Sandeep Verma · 05-22-2014

Hi All,I have 5 sites connected over MPLS-VPN. BGP is running as egp. All sites are ebgp with ISPI have a default route being learnt from ISP at all sites. I want to advertise default route from one of the MPLS sites so that others can reach here for...

Sandeep Verma · 05-30-2018

Hi , Did this issue get resolved anyhow ?ThanksSandeep

Sandeep Verma · 09-01-2015

Hi Robert,Thanks for your response!One thing, i have the normal BGP routes redistributed on WAN1 into ospf, which are learnt on Core Switch as LSA Type5. Would it cause any issues for these redistributed routes ?Otherwise this seems a perfect soluti...

Sandeep Verma · 08-31-2015

Hi Robert,Thanks for your response... please find attached. RegardsSandeep

Sandeep Verma · 08-24-2014

Thanks for your response guys....! Below are the details :AP Model no. AIR-SAP2602I-Z-K9Software Version7.6.100.0i could ping CISCO-CAPWAP-CONTROLLER to correct IP address.Connection from remote site to controller site was also UP.(could ping both e...

Sandeep Verma · 08-24-2014

Thanks Leo.....!

Member Since	‎12-05-2013 01:13 AM
Date Last Visited	‎06-07-2018 04:45 AM
Posts	42
Total Helpful Votes Received	10

User Statistics

User Activity

no-export community with summary address using attribute map- won't it advertise the prefix to direct eBGP neighbor ??

Network 0.0.0.0 under BGP process --- Does this change route selection criteria ?

AP in Flexconnect mode not registering automatically to WLC after Link Up

Controller port error, Interface Gi3/0/28: Power Controller reports Short detected

Choose BGP default route from one of the MPLS sites ignoring ISP default route

Re: ISR4331-3x1GE - interface down line protocol down

Hi Robert,Thanks for your

Hi Robert,Thanks for your

Thanks for your response guys

Thanks Leo.....!