About gregalink

gregalink · 12-14-2013

Hi,I have recently been tasked with upgrading our old Autonomous APs to LWAPs. We have a 5508 WLC at our Virtual Co-Lo and I am using Flexconnect to accomadate local switching and dhcp at our sites. I have upgraded over 50 APs and joined them to th...

gregalink · 03-06-2014

Alright, so this ended up being a combination of a couple different things. Firstly I needed to change a default gateway for the WLC interface at our CoLo because the WLC couldn't route traffic to all locations. The other and most important find w...

gregalink · 12-30-2013

I had forgotten to save the putty log file from my console output when I was on site. I will be sure to attach it next time. Also, I believe the APs I already have registered should stay connected long enough for me to issue the above commands. Th...

gregalink · 12-30-2013

Hi,I was out of town for the Holidays and enjoyed some much needed time away from technology so sorry for my delay in getting back to you all. Here is what I have done so far. Rasika, I did change the recovery image on one of those APs to ap3g2-rcv...

gregalink · 12-16-2013

Thanks for the advice Leo and Rasika. I actually had my first experience today using a TFTP server to downgrade from Lightweight to Autonomous on an old AP with no certificate so this shouldn't be too difficult. I'll be at one of our facilities tom...

gregalink · 12-16-2013

Ok, umm... there is no way for me to currently move the AP to our Virtual CoLo which is not at the main office. It's in a highly secure data center and I would need to schedule time in advance and not even sure I could hook up the AP inside of the f...

Member Since	‎12-14-2013 07:54 AM
Date Last Visited	‎08-18-2017 04:28 AM
Posts	9

User Statistics

User Activity

Trouble getting Cisco 2600 Series AP to stay joined to WLC 5508

Trouble getting Cisco 2600 Series AP to stay joined to WLC 5508

Trouble getting Cisco 2600 Series AP to stay joined to WLC 5508

Trouble getting Cisco 2600 Series AP to stay joined to WLC 5508

Trouble getting Cisco 2600 Series AP to stay joined to WLC 5508

Re: Trouble getting Cisco 2600 Series AP to stay joined to WLC 5