gwatkinsqt
Level 1
Level 1
Member since ‎12-27-2013
‎02-14-2018

User Statistics

  • 12 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
5 Replies

User Activity

I have access to CML at work and I've built a couple simulations.  I would like to have the ability to simulate actual network traffic.  I have a small network simulation setup with two managed servers on two separate networks.  I have my network set...
I'm running PrimeLMS 4.2.4.  I'm wanting to setup reverse telnet on several remote routers, so I'd like to use a NetConfig job to push out the configs.I'm setting up a hostname on the routers to telnet through the aux port using the loopback0 address...
I'm working on a Baseline Template for compliance.  One of the interfaces that we use across all our routers is Loopback 1.  I want to use a baseline template to check if Loopback 0 exists and then if it exists, I want to check certain lines in its i...
My company is running Cisco Prime LMS 4.2.4.  I would like to be able to track configuration changes and also be able to see who/what made the config change.  I need to be able to do an on demand configuration change discovery, a daily change discove...
My organization is running Cisco Prime LMS 4.2.  I recently added some devices via IP Address.  For some reason, I can't get it to update the device inventory with the device hostname.  I've checked the device credentials and they are good.  I've rem...
Community Statistics
Member Since ‎12-27-2013 02:09 PM
Date Last Visited ‎02-14-2018 02:10 PM
Posts 12
Total Helpful Votes Received 15
Helpful Votes From