I have two cisco routers currently running ip cef. The gear I have is a 3745 router at the central end and a 2611XM router at the far end. I am load balancing two T1s between them. The WICs are VWIC-2MFT-T1 cards at both sites. The weird problem I am...
Hi, I am trying to see if my Cisco3600 will perform a strange nat scenario. What I would like to do is have one inside local ip address that is natted globally to more than 1 ip address. For example,I have device with ip address 10.10.10.10 on th...
I have a situation where I need to multilink 2 frame-relay T1s. I have read the doc on how to do this and am not clear. The doc says to configure a subinterface off of the new MFR interface and configure a DLCI for it. My confusion is this part. Is t...
Hello, I am trying to find out some info on multilink. My company is looking at connecting to a remote site using Multilink. We currently have a 2611XM located at that facility. The plan is to drop a VWIC-2MFT-T1 card into the 2611, order two T1...
Hello, I am trying to find out for sure if the VWIC-2MFT-T1 card will support ppp multilink. We have a situation where we will be linking 4 T1s between our site and a remote site. I was thinking of placing a 3600 series router at both ends and ...
Thanks for the clue!!! I was putting together the output and noticed that the ospf cost for the new WIC was 64 and the pre-existing WIC had a cost of 65. I am not sure why the new WIC had a cost of 64, maybe because it is a single T1 instead of a dua...
That is a fair question. I have a remote office that needs to replicate a large amount of data weekly to our central site. I am trying to bundle the links to get a greater amount of bandwidth for the replication process. I have done multilink bundles...
Thanks for the reply. My question is now this. The way the two T1s were ordered, they each have a dlci number which corresponds to a dlci number on the far end. On the one logical interface, which DLCI number do I use? To get frames switched through ...
Here are a few steps. 1) Enter config mode ( config t ) 2) type 'controller t1 (number) 3) setup the linecode and the framing here. 4) then you can type channel-group (number) timeslots (number of channels) speed 64 This will then create ...